Help my car is not going properly again.

Page 1 / 2
doomy999, May 4, 4:16am
Any ideas on whats wrong please!

hamishcookie, May 4, 4:17am
Stuffed apex seals!

curlcrown, May 4, 4:17am
Clearly the head gasket is blown.

thunderbolt, May 4, 4:19am
ID Ten T error without a shadow of a doubt.

skittles93, May 4, 4:25am
4

icemans1, May 4, 4:26am
faulty flux capacitor for sure!

martin11, May 4, 4:30am
Hopeless driver

a.woodrow, May 4, 4:59am
the owner.

nightboss, May 4, 5:07am
Operator has a screw loose, give operator a few hits with hammer then retry. Good luck.

countrypete, May 4, 5:07am
It's the blardy blow-off valve you installed!

floscey, May 4, 5:20am
the nut behind the wheel is loose.

doomy999, May 4, 5:51am
I just come in here for a simple solution and you guys cant help but start being mean and bullying me.
If you dont stop with the mean remarks Im going to leave this place for ever and never come back until next week when I get bored again.
So please be kind and fix my car for free for me by using your incredible intelligence to diagnose it for me over the interent with out a shred of information to go on.
Sorry I think I forgot to mention it was a metallic blue car. I think!

jason18, May 4, 5:53am
You put the water in the petrol tank and the petrol in the radiator.Silly man

snoopy221, May 4, 5:56am
help my car is not going properly again.
it was a metallic blue car

Well repaint the damn thang metallic blue again.

jmma, May 4, 5:57am
Metallic blue, that's the problem, spark is shorting out on the paint job, paint it red (o:

snoopy221, May 4, 5:57am
I just come in here for a simple solution and you guys cant help but start being mean and bullying me.
If you dont stop with the mean remarks Im going to leave this place for ever and never come back until next week when I get bored again.
Harden the.up

msigg, May 4, 5:58am
what a dor.

mantagsi, May 4, 5:58am
bloody troll, thread voted

doomy999, May 4, 6:01am
darling starts with dar, not dor silly. :-)

doomy999, May 4, 6:01am
aww I love you too.

snoopy221, May 4, 6:02am
Actually a moot point but when you paint metallics you should use CLEAR coat-not QUEER coat.

doomy999, May 4, 6:02am
that does it. Im gone. Im out of here for ever.
good bye for ever snoopy.

doomy999, May 4, 6:03am
whoops changed my mind.
back again. lol

snoopy221, May 4, 6:06am
ha ha the ole Rodney Rude line-ya shwn ya age mate.
LOL
Taxi-got room for a pizza and a dozen.
**chunder**

andrew499, May 4, 6:06am
Have you tried putting an engine in it! After that, perhaps a battery!If you've already tried this, please ignore above suggestions.