Clutch trouble. Ok where to start bought a brand new gbox for isuzu elf couldnt get into gear so had to shorten selector arm as

Page 2 / 2
jmma, Apr 25, 4:48am
Did the box bolt up OK or did you have to wind it in with the bolts that last little bit!
crzyhrse, Apr 25, 4:52am
I'm picking the latter.
snoopy221, Apr 25, 4:53am
Gawd now we understand. AHEM.
Um ya remind moi of an ex sd23 nissan i was in the other night with a td23 motor and box and reversed linkages.gawd.juss a new box.
mmmmmmmmmkay
um-um. merconaaaaaaaa
(well it's gotzz meeereeeee ummsssss)
seems ya got a cheap but wrong box-try sorting the go box numbers and model ID'S before ya blame the clutch methink
scoobeey, Apr 25, 4:53am
had to bolt my bellhousing up to new box .smaleer bellhousing .used my old clutch fork and used dumy shaft off old box to centre and it seemed to bolt up ok .i did have to wind in last little bit yes
jmma, Apr 25, 4:56am
Its pointing to spigot bearing not matching new shaft or damaged putting it in
jmma, Apr 25, 4:58am
or input shaft to long and jamming on bearing
scoobeey, Apr 25, 5:05am
So measure up shaft and compare with an old box !
jmma, Apr 25, 5:07am
Perhaps you could try backing bell housing bolts off a little and see if it works then to confirm this.
scoobeey, Dec 9, 9:09pm
box out at the mo but yes cheers good idea